NOS bottle warmer help!

[TitaniumVtec]

NOS bottle opener help!

I'm doing some NOS work and forgot the wiring for my bottle opener. Does anyone know which wire is ground? My guess is black, but it couldn't hurt to ask.

Thanks in advance,
James

 

[BadCarma]

the ground is the white wire. red and black to switched 12 volt. hope that helped.

 

[TitaniumVtec]

Just what I needed. Thank you very much!! I guess my guess was incorrect. Glad I asked.

Thanks again,
James

 

[BadCarma]

dont forget to put a fresh teflon washer on the mating nut,the one on their is all but gone.did you get the switch hooked up?
(note) you can use a jumper from the center pin on the bottle switch over to the center pin of your master arm that way you can open and close the bottle even with the arming switch off and open and purge line so as to be ready to spray and activate at last minute, also get rid off the right angle 4 -an connector that is on the valve that the supply line hooks to and replace with a russell elbow that is a 45 degree bend.makes for a much smoother flow line for the n20.replace all of your 90 degree fittings wherever possible. you will notice an improvement on the hit at lower pressure (note) activation at to low a pressure is as bad as to high. keep the bottle stable at 1050 psi, I know NOS recs a lower psi but 1050 is optimal.

 

[TitaniumVtec]

Yes, I happened to hook it up just like you mentioned. Not realizing that opener does in fact work with the master power off. I see that the teflon washer is in need of replacing. Thanks for spotting that. I will also replace the 90 degree elbows with 45 degree ones. Thanks again for the tips.

All I have left to hook up is the MSD Window Switch. I had sent you an email regarding that a while back, but you are very busy and I'm sure you simply over looked it. I just need to wire it up and I'm ready to go.

Thanks for all you advice David,
James