I installed a Dali clutch and light flywheel. I am getting a slight shutter and without yanking the whole thing apart, can I reinitalize the clutch. Thanks
Originally posted by tunapie: I installed a Dali clutch and light flywheel. I am getting a slight shutter and without yanking the whole thing apart, can I reinitalize the clutch. Thanks
As Gerard mentioned you can. I have to tell you I have a low confidence level that this is your problem. Did you use the Honda Urea grease on the clutch splines? If you used an alternative grease type, this could be your problem.
It is very important to use this grease and the correct amount.
I was coached by Mark Basch on throwout bearing prep. The shutter is so slight but I try for perfection. After pulling off the tranny cover plate I did not see enough room to re-adjust. Thanks, Dan
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.