When ever I roll over bumps or drive on a bumpy road the headlights of my NSX bounce up and down. Was not sure how to secure them to prevent this issue.
I have been searching the forum for help and unable to locate anything on this topic for an 01 / earlier model.
Last edited by NSXRAY1; 04-08-2012 at 18:04.
97 Formula Red/Tan NSX-T
2006 Honda Ridgeline, 2006 Honda Pilot, 2004 Honda Element, 1990 Miata
Where is the mechanism located? thanks
Last edited by NSXRAY1; 04-08-2012 at 18:53.
this section of the wiki/FAQ?
You also might want to take a look at the sections of the service manual that describe the retractor system and the removal of the headlight units. They're under the Electrical section; look for the headings for Lighting System and for Headlights.
Last edited by nsxtasy; 04-08-2012 at 20:21.
NSX. Spread the word.
I appreciate the help. I will check into it.
Just a note, I have tightened the stoppers and mine still bounce a bit when hitting pot holes or RR tracks. With the headlights up, if I apply pressure to them by hand they seem rock solid, but still wobble.
Are you missing the rubber hats for those screws? Should be two per side. Mine was shaking quite a bit until I bought these and put them back on.