Sway bar end links - help

[jaffaz32]

Any one else have any problems removing the end links nut?

I have searched and realize you need to use a 6mm allen key. That isn't the problem, the problem is the allen key part. Bad design.


the problem is it wobbles about too much and can't get a good hold on the allen key. I have loosened it off to a certain point and the nut is near the end but i'm concerned if i give it too much the allen key part will churn up inside and i will be in trouble.

It's so close to the end. I have used lots of WD40.

It doesnt even want to do back up again.

Is there another alternative to looking into aftermarket adjustable end links?

And i thought sway bars would be easier to fit, :O

[whitebois]

Make sure to jack up both sides of the end you are working on. Keeps tension off the bars.

[nsxnut]

Use an allen Socket...

http://www.sears.com/shc/s/tools-wre...sid=21x1460826


Like what whitebois said.
You need to jack up the front end.