i would not recommend this process unless in an emergency situation!
The backspacing is different which required more material off the inner surface than outer!
OEM front rotor is 28mm thick vs OEM Rear is about 23.5mm thick. Had to take off to much for recommending the process to anyone else except in the case of an emergency!
Plus, the oem 97 spec rotors ARE slightly smaller in the front than rear which left a little bit of pad overhang!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.