Hi,
I bought a 1991 NSX that was stripped for track use and an SCCA approved roll cage installed. I want to put just enough street equipment back on the car so I can pass Utah state inspection and drive it on the street as well as on the track. The previous owner removed the windshield wiper assembly to setup the roll cage. The right roll cage strut passes through where the windshield wiper motor would normally be, so I need to come up with a custom windshield wiper that can fit even with this roll cage remaining intact. Does anyone know of an NSX that has had this done, or any ideas about a good way to go about doing this?
Pics of the roll cage area in question:
broader view:
I bought a 1991 NSX that was stripped for track use and an SCCA approved roll cage installed. I want to put just enough street equipment back on the car so I can pass Utah state inspection and drive it on the street as well as on the track. The previous owner removed the windshield wiper assembly to setup the roll cage. The right roll cage strut passes through where the windshield wiper motor would normally be, so I need to come up with a custom windshield wiper that can fit even with this roll cage remaining intact. Does anyone know of an NSX that has had this done, or any ideas about a good way to go about doing this?
Pics of the roll cage area in question:
broader view:
Last edited: