A little bit of analysis based on how NSX ALB operation described in workshop manual. I strongly believe my piston leak was due to the small o'ring (2 x 6 mm) described in this picture
http://www.nsxprime.com/forum/showthread.php/162710-ABS-ALB-modulator-rebuild-write-up/page7
I went ahead...
Brake fluid leaks at the top of the pistons and spills out of the air holes. I guess it is one (or many) of modulator piston rings goes bad. Ideally, if I can fix this by replacing orings, but if not, I would take your suggestion to find another unit or probably will buy new piston as suggested...
After reading a little more on the forum. It is obvious that my ALB modulator pistons (not the solenoids) are leaking (at least the two on the outer side). However, I don't hear pump constantly running (as mentioned in other ALB leaking threads). I check and manually activate the pump for 20...
My ABS was leaking at the Modulator valve cap where there are 2 holes on both end (red circle)
I thought O-rings are shot. So I went ahead to rebuild it with new o-ring kits by following this thread http://www.nsxprime.com/forum/showthread.php/162710-ABS-ALB-modulator-rebuild-write-up
It...
This car has been advertised for around $90K iirc. I think he put that price up as he has deposit. But that is really silly to put the price like that.
[please ignore] Coilover advice needed
I am looking at getting Coilover for my sedan 328i pre-face lift.
Looking at eBay, I saw Tein Coilover for BMW.
http://www.ebay.com.au/itm/201376583872?_trksid=p2060353.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT
Anyone have experience with Tein Coilover...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.