Search results

Last night I watched the NSX drive off with a new owner at the wheel. I really enjoyed the car and this forum has been a wealth of information during the time I have owned it. I was not actually looking to sell but one day a few weeks ago I was looking at the WTB's and found Alex's posting and...

Attended an driving event held at Waterford Hills track north of Detroit on Monday where we were able to drive several cars a couple of laps each. The company (Executive Drive) is based out of Indy and provided the cars and staff. I attended as the guest of a supplier company. Just a few short...

Well my failure matches the FAQ to a T. Went to open the door and I heard the crack and then the door would not open from the inside. The FAQ shows a list of parts that are part of a "Kit". Door lock switch/cable Latch spring Mounting brackets The latch itself Latch housing. Is this an...

Had the transaxle fluid replaced a few weeks ago with synthetic and asked the tech about any additives that might be required due to the limited slip and was told that they were not required. I just did the same on my 911 and it did require an additive. I checked the FAQ section and only found...

With Devin out of the picture at Payn I am looking to have a dealer service my car. I need a timing belt, tune up, all fluids changes, filters, and.. I have gotten quotes from both Suburban and Jeffrey Acura. Both quotes are about the same, in the low $3,000 range. Anyone have experience with...

I have noticted several posts regarding Baker's Restaurant car show in Milford. While I have never attened, actually I had not heard of the show until I read something here at NSX Prime, it sounds like a great event. I just received my new P4 monthly mag from the S.E. Michigan Porsche club and...

I purchased a 92 35K mile manual a couple of months ago and want to do general maint. this sping. I am the third owner and the car was sold by Jeffery Acura and serviced there since new. Acura of Troy is less than a 1/2 from the office as is Payn Technologies. I want to to have the timing...