Search results

Gerad, I'm looking for a price on a few parts... Both side front plastic fender wells. And plastic fasteners for same. both side Targa removal handles (don't ask) Passenger side window switch. Drivers side window switch. Thanks so much GEM

Don't ask how I know (you don't want to know the answer), but when an officer testifies to a radar ticket he testifies to his visual estimation of the speed. The radar is only for comformation. You can be cited for speed base on visual estimation only (no radar needed) particular if the...

I talked to Factor X today and they suggested I only fix what is broken. So off to the garage to put the heads back on....Wish me luck. Thanks for all the help! GEM

Well, ARP does not show an NSX application. I also checked the manual again and it does not say to replace the bolts. I don't mind spending the money on new bolts, I'm just not sure it is necessary(since they are non-stretch), and I don't know how long it will take to get them. I also tried...

I have had no luck on getting a hold of the original owner. I doubt he would tell me anything, anyway. Does anyone have any idea if the welded spot on my manifold is supposed to be there? That may be the cause of the head bolts pulling out (NOS???). My valves were leaking as well. I will...

Lets try this....

I’ll try to put a picture of the weld on the bottom of this post, but I can’t promise anything. Well, it is do or die time on the heads. Can anyone offer any last minute advise on time-serting all 16 or just sticking to the 2???? If I don’t get any advise to the contrary I think I will stick...

Only mods to the engine are exhaust and K&N. No head work. The car only has 40K miles. I had it check out by a dealer in FL when I bought it. It had 28K when I bought it. The only thing that makes me think something may not have been stock is I found what looks like a welded up port or hole...

The bottom two head bolts (#1 cylinder) pulled out on my 1997 NSX. - I guess I know why I blew a head gasket now. Anyway, any advice or suggestions on time-serting just the 2 or should I do all 16? I did a search and I could not find anything on head bolts, so this must be an isolated kind of...

Thanks! The FAQ was not much help as I needed the engine views, but Sunnyside did the trick!!!!!! GEM:)

Does anyone know where I can get an exploded parts list of the engine for a 3.2? I have the Acura shop manual, but it only shows the exploded view and says something like "o-ring (replace)". It does not give the part number like the 1991 parts list located here. Any ideas? Thanks GEM:confused:

Hi! I believe I replied to a post you had on NSXSC a short time ago about the GT Lightweight I purchased from SoS. I too wanted an increase in volume, but did not want it to be out of control. The GT is perfect! I was actually going to buy to JGTC, even though it was a little louder than I...