Hello - I have a burned out bearing and pulley in my supercharger (1991 acura nsx) that needs to be replaced. Having trouble contacting CT engineering comptech (comptech is back and purchased CT engineering?) Thanks for any help!
Last edited:
-
Protip: Profile posts are public! Use Conversations to message other members privately. Everyone can see the content of a profile post.
CT engineering 91-05 twin screw supercharger bearings, belts and general parts needed
- Thread starter ACURANSX91
- Start date
I'd try reaching out to HQ Engineering in San Gabriel CA, they sourced the last batch of replacement parts I needed for my CT SC.
Jon bond should have all the parts you need: https://www.jonbondperformance.com/
Post a pic of the supercharger for identification. It’s probably a whipple 1600, but a pic would verify
Post a pic of the supercharger for identification. It’s probably a whipple 1600, but a pic would verify
Assuming you mean the main sc pulley, griptec can make you one that is better than the comptech unit. Here’s my whipple 3.5” / 9.5psi unit from them. If you have the whipple, you can send them these pics and they can make you one with any diameter you want. The low boost, (6.5psi on a 3.0) pulley would be 3.765” diameter
MIght give Eaton a yell
thehighspeedlab.com
CT Engineering Supercharger Nosedrive Rebuild Kit with Needle Bearings
CT Engineering Supercharger Nosedrive Rebuild Kit with Needle Bearings -- This item includes the same high quality parts we use in our supercharger rebuild services. This kit contains the parts needed to re-manufacture a supercharger nosedrive assembly and replace the rotor shaft needle...
Similar threads
