I'm trying to replace a blown speaker, but having trouble figuring out the correct way to remove the door skin. Any help would be very appreciated.
Ken
Ken
-
Protip: Profile posts are public! Use Conversations to message other members privately. Everyone can see the content of a profile post.
Driver side door skin removal
- Thread starter nsx911
- Start date
We covered this topic at www.nsxsc.com a couple of weeks ago. It might be a good idea to go and search either in the general disc. or Brent Cobbs maint./repair sections.
If I remember correctly, you have to take off all the screws around the edge of the panel(under the weather stripping), as well as the one found behind the smallest leather padding in the center of the door(right behind the handle). You must pull off the smallest leather padding to get to the screw. A service manual would be helpful if you have one. After this I believe it's just a matter of pushing the panel upwards to get it off, then disconnecting the power cables behind the panel. Be sure not to force it off or to pull the panel off very hard because you might damage the wire connectors, or something else.
Hope that helps a little, and if anyone wants to add/correct anything feel free.
------------------
Richard
NSXTASY
[This message has been edited by Veleno (edited 08 April 2001).]
If I remember correctly, you have to take off all the screws around the edge of the panel(under the weather stripping), as well as the one found behind the smallest leather padding in the center of the door(right behind the handle). You must pull off the smallest leather padding to get to the screw. A service manual would be helpful if you have one. After this I believe it's just a matter of pushing the panel upwards to get it off, then disconnecting the power cables behind the panel. Be sure not to force it off or to pull the panel off very hard because you might damage the wire connectors, or something else.
Hope that helps a little, and if anyone wants to add/correct anything feel free.
------------------
Richard
NSXTASY
[This message has been edited by Veleno (edited 08 April 2001).]
Here's the link to Brent Cobb's "How to" on door panel removal.
http://www.nsxsc.com/ubb/Forum17/HTML/000022.html
http://www.nsxsc.com/ubb/Forum17/HTML/000022.html
