Recent content by jsullyboy

Victory! The tracks are greased. Bushings replaced. The grease the Acura dealer gave me works very well. 3 nights of messing with the adjustments. I replaced the surrounds with the MITA trim because more than half the tabs were broken. I mimicked the factory felt on the trim. The Mita parts did...

Thanks, I played around with it for several hours today. Its definitely a combination of the regulator position and the stoppers at the top of the door. I have reduced the sound but not completely eliminated it. It only makes it slightly now when it goes down. The speed is really good now even...

To hold the window I cut a few 1x3 poplar boards and routed a grove in the end to allow the glass to slot into. Then I secured the boards using existing holes in the door. This held the window up. I also painter taped it just to be paranoid. I got the regulator out and with gorilla force...

Thanks for the advice! I think the driver side has been cleaned before. I managed to get the guides really clean. I could run a shop paper towel up and down both guides without any resistance or collecting any dirt after cleaning. The passenger side may not be the same. I may have to remove...

Thanks, one follow-up question to raise the window after removing the bolts you raised the window by pulling it up? You didn't run the motor to raise it. I cleaned the tracks in the door. Took some contortions but with patience I got there. My local Acura dealer gave me a tube of grease for the...

Yes, thanks!

Hi Folks I am trying to fix a creaking window. Got the door card off cleaned and regreased the tracks. I have the SOS plastic bushing for the regulator. This is 100% the problem as I found fragments of the old ones floating around the door. The SOS instructions are not the best, so I am...

In my S2000 I use a FM transmitter for Bluetooth audio. No modifications needed. Just plug it into the cigarette lighter and tune the radio to the frequency on the device. Plus it adds phone call capabilities through the stereo too. For whatever reason in the classic cars it just feels right to...

I got my full original stereo system working! My car is a 1991 it had the original head unit, amps were done in mid 2000s, it has the original CD changer but no cartridge. The head unit would not turn on when I got the car. Reading through thread I discovered this is a common problem with these...

Thanks, I found one for $18. Worth to see is the cd changer still works.

Will the Apline 4905 cartridge work with the oem cd changer?

I finally got my radio working. Looking for a cd changer cartridge. My changer does not have one.

Got it out. Thanks to you both. The picture in the service manual is a little confusing. By lifting up the rubber seal with a good light I was able to see the metal tab. I put painters tape over the paint to protect it then used a flat head precision screw driver to push in the tab. Its tight...

Any advice for how to get the side marker off without breaking it? I looked in the service manual but don't seem to be able to find that tab to press on.

I use this bluetooth device in my S2000. It’s non-intrusive and works well. Bluetooth adapter When i get my stereo working i plan to use this in my NSX