Looking for a replacement AC Suction pipe the one that comes out of the fire wall manifold loops back around behind the battery over the sub frame and back under the car. It has the High side AC charge port attached.
Looking for a replacement part. I end up taping it with a wrench while...
I ran Eibach pro spring kit and stock shocks for about 15 years. When the shocks needed to be replaced I went with Koni yellows that’s what it’s on now. The lowering springs are a lil harder on the stock shocks and lowers there life expectancy but mine seemed to hold up and last a long time...
That’s what I'm looking to do.
I want to attempt to swap in modern guts on an old unit. I found some units designed specifically for retro fits. It would lose the tape deck function and presets (I’m ok with) but gain the ability for Bluetooth all while looking completely stock. There’s even a...
Could be the switch in the door lock. I have to unlock mine from the passenger side so it don’t set the alarm off with the key. Mine went bad a while ago I just never pulled the doors apart to fix it yet. Have you tried unlocking it from the passenger side?
Installing a keyless entry will...
Is there a decent aftermarket mat that fits like OEM that we could put these on. I don’t see that fitting over the OEM floor-mat logo. Unless it’s really big.
I have run the HPS Street pads on my car for years but I couldn’t tell you if it had a pin on the backing plate. Zero issues they bite harder dust less and are quite I love them and will replace them with the same pads when the time comes.
Yeah I remember how collage was jammed down kids throats. Now we have an entire generation of children trained for jobs that don't exist now being outsourced to AI still living in their parents basement now doubled down in debt as interest rates skyrocket out of control. Good luck with that path...
I purchased mine at 19. But I was buying and selling cars long before that. My family owned a used car dealership. So I was buying them cheap at dealer cost and flipping them for profit. I had several trade skills under my belt at that point, and had just sold my Corvette for a relatively good...
I’m doing mine this winter for peace of mind. Thanks for taking the time to do a How-To video this will come in handy.
BTW I would love to see an Early ABS seal replacement/ rebuild video. I have been sitting on the seals to replace mine for a while. I just haven’t attempted it just yet.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.