just an update for anyone following, Patatina was right about the piston! when looking at the piece that appeared as one but sure enough after popping it back in the cylinder and tapping it lightly it sprung open! the pump makes much more sense this way ;) cleaned it out (may debur if needed...
Back again!
So as I mentioned, upon reassembly there was no fluid movement or pressure. Out came the pump again but this time decided to take it down past the check valve. Took some effort to pop out this piece which I can assume the pump makes contact with allowing the spring to compress...
one step forward two back... cute little in/lb tq wrench ;)
Got everything back together but for some reason I'm not getting any fluid to the pump. Ppened the bleeder, ran the pump, toggled the solenoids and no luck. Even bypassed the reservoir with a syringe full of fluid and the pump...
Hey Guys,
Hope everyone is doing well. I for one, have been able to get after a number of NSX projects I've been putting off! steering tie rod and endlink, new rear fender liners, front radiator air guide, ect.
HOWEVER, the ABS has got me stumped. After pouring over pages and pages of stuck...
I should be in +1 for the first half of the day. TBD on what we'll bring maybe a papaya salsa and chips... or maybe yakitori if I get around to finishing the DIY grille
Simple as the title.
Ivory Sun Visors - All three needed, not split.
Seats - Drivers bolster must bee in good shape. Local SoCal is best but could drive if really nice.
thanks
_Paul
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.