Recent content by GTLabAustin

Thank you. I actually found that just after asking. Spent a little time working on it again yesterday and will likely test the system later today.

Just to confirm 100%, when the schematic says "Wire side of Female Terminals", this references the view when looking at the wiring harness, correct? For example, If I'm looking at the EPS controller, position "1" as shown on the schematic would be in the upper right position, correct?

Ahh, you're absolutely right. I was referencing the pre 97 schematic. Thanks again for pointing me in the right direction. I will look for the correct version and modify my harness accordingly. Hopefully I can get this done and document the details for anyone that's motivated to do something...

We must be looking at different manuals(?), because 17-19 in my 1997 manual shows removal and installation of the steering gearbox. Here's is what I've been referencing for the 18 pin connector on my EPS controller (below). The wires I mentioned above that I'm trying to identify (white...

Old Guy - Could you tell me where you were able to find a schematic for the rack wiring harness? I looked at the manuals again and couldn't find where you located the "Internal Wiring for 6-pin connector" I have only three wires left to identify and connect before testing. The wires come from...

This is sooo helpful! Thank you

Sorry, I tried to reply to this days ago, but my posts did not show up. Not sure why, but seems to be working now. Old Guy - Thanks for taking the time to look into this! I have also reviewed the pages you referenced in the shop manual, and have not been able to answer my question. Do you...

test

I'm interested. Shoot me your contact info when you have a chance Thanks!

Thanks for taking the time to look into it! I've reviewed the pages you referenced and haven't been able to figure it out. Do you have any idea where I could locate an internal schematic for the power unit? I have not been able to find one. Here's a few more details on the parts I'm working...

Thank you for taking the time to look at the service manual, I really appreciate it. I have been reviewing page 17-40 along with the electrical schematics you mentioned at the end of the manual. They have been very helpful, but I'm still down to identifying these wires coming from the rack...

Hey there everyone, thanks in advance for any help provided here. I'm currently converting my 91 manual NSX over to EPS, but have hit a bit of a snag. What I really need some assistance with is identifying the wires coming out of the rack itself. I've looked at all of the available schematics...