I figured out which wire in the harness controlled the antenna and installed a switch. Now the antenna only goes up when the switch is on. I installed the switch in the armrest compartment. I did not want to take out the factory antenna.
Tim is really good. Remember this is probably a multi-year part so he may have ideas if it is not available. He should be able to help you nail down the part number. You could then look on eBay if he can not get it.
https://www.oemacuraparts.com
https://www.oemacuraparts.com/v-1991-acura-nsx--base--3-0l-v6-gas/body-air-conditioning--hood
Call Tim Poliniak
Acura of Peoria
*(866) 347-8355
I think in most cases you want to take the housings out. First, there is a pesky clip that you need to maneuver around the light bulbs. Unlike most cars this clip is what holds the lights into the housing. The lights I bought had an allen screw that when loosened allowed the housing to come...
I put an antenna defeat switch in. I had to figure out which was the power wire on the antenna and ran wires and installed a switch in my center armrest. I never use the antenna since I have an aftermarket radio with an aux in.
I had the car out Saturday night and had issues with the right side low beam not coming on for a little while. I decided it was time to replace them. The first set I got from Amazon was no good so I returned them and got these:
Fahren 9006/HB4 LED Headlight Bulbs, 120W 20000 Lumens Bright LED...
You really need to measure the amount you need behind the bulb. This depends on the transformers, etc. These are vented so it is much better than what I had before. Russ is on this thread and he was an invaluable resource.
I believer I used 90mm for the low beams and 105mm for the High...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.