Recent content by S2G-Unit

I followed advice that I found on another thread & it said to try removing and cleaning the blower motor. When I opened it, a bit of dirt and sand came out. I re assembled it and it has worked fine ever since. I gave it 1-2 weeks to make sure it works fine before replying to this thread. Thank...

Any idea why, it was showing 13-14v no matter if it was set to low or high fan speed?

It randomly started blowing this morning but I'll check what you suggested this sunday. Thanks.

I opened up my relay box & then I remembered over 10 years ago my dad & wired up a replacement Denso 56700-7250 relay for the blower motor & hid it in the bottom of the relay box. We tested the 2 pin connector as suggested. With the CCU at minimum fan speed & maximum fan speed, the multimeter...

Yes, I did remove that little sensor probably 10 years ago when others said it provided no benefit. I do remember it ticking & making noise. At the time, I think Briank was repairing them.

Thank you for the detailed response & Cycleterminal.com. I'll add that when I did the CCU self test & pressed both buttons on my climate unit, the only thing that came on was "MODE".

I've been reading through the forum but need some guidance for 1994. -In 2012 I had BrianK repair my CCU. -2 weeks ago I had my AC Freon refilled before summer started. However, in April & May, I noticed when I turned on the CCU sometimes it would take a few minutes before it would start...

I just started my car, It started just fine. As I sat in the car, after a few minutes the car died. I turned the key in the ignition & checked the voltage on the dash. The battery seemed fine above 12v. I started the car once more & it has been running fine for about 15 minutes with the voltage...

I believe I have that filter in my parts box already. I think I ordered it when I started this thread. I'll take it out, thanks.

Thank you. Not to throw money needlessly away but if I were to buy those sensors, do they come from Honda already setup? Any adjustments need to be made? I believe I saw that one the sensors I had listed above required adjusting a screw for idle?

Bumping my old thread. Last year, I only drove maybe, 2000-5000km's. I had a broken windshield & it took I think 3 months to get a replacement. After parking the car, I forgot to put on my battery tender, the battery died & needed to be boosted. Once boosted, I let the car idle for a few...

Emailed you to confirm they were by the first person to respond.

Sorry, I didn't get any notifications for PM's, conversations or this reply (anybody else having this issue since the forum change???). A few people contacted me. Someone was before you. I responded to him first. If changes his mind, I'll email you.

SOLD My friend ended up replacing the whole inner door handles. These have never been unwrapped or used. Sells for 400$ + shipping at SOS. Will be shipped from Montreal to elsewhere in Canada or the lower 48 for 370$ USD shipped. I'll take Paypal as payment. Thanks,

I was so happy I changed the balancer for my 2nd WP/TB. The engine was so much smoother for me under acceleration & especially at idle.