Recent content by watchdogd

I literally don’t even realize it was ever taken out. My car is not modified other than an intake scoop so I might not experience the same with others that have more mods.

I posted a video recently showing one of my plates was loose. FWIW I have not noticed any difference so far at the low end with throttle response or lag but I do not track the car.

I just had the IAB delete kit recently installed at SOS and thought I would pass on condition of my plates which are from 2005 NSX. Kudos to SOS for designing the kit. My car has 66K miles. I have noticed zero difference on my car but I dont have anything special other than the Downforce...

I know this is an old thread but props to showing a picture and being able to walk through the steps. I was stuck on not being able to pull the rod out of the plastic piece and then I tried something that I thought to pass along was getting a "blow dryer" on max heat to heat up the plastic and...

I recently had my door checker replaced because it made a rubbing noise that I was unable to eliminate. The new checker makes the rubbing noise like the previous one. A few people I have spoke to mentioned that maybe the door is not aligned properly since it had been previously removed a few...

To clarify it goes into the body. https://ibb.co/LvzYSQr

Thanks for providing that link. I have an 05 so its the bolt you see if you remove the side skirt where that part on the front has the double sided tape is It looks maybe like #44 but i cant tell for sure.

RE: Question on Part Number I am looking for the part number of the bolt to the lower part of the front fender. In the diagram I can see a representation of the top 3 bolts but am unable to see anywhere what the bottom bolt is. And is there suppose to be any washers with it. Thanks,

I just had the GROM installed and it worked twice then now I no longer have the option to select CDEEE. Has anyone seen that where the only options are AM/FM when I try to toggle ? update as soon as I disconnected the battery and reconnected everything works as expected. Thanks again for...

I received my GROM and wanted to know from looking at the pictures I am unsure do I need an extension cable to the Join or the default one is more than enough ? Thanks!

These images are great thank you for providing them, very helpful. Very convincing to go this route

So you mean from the CD changer to behind the drivers seat ? So the unit is accessible behind the seat to pop in a USB stick . I was imagining enough room to run it on the passenger side floor area but sounds like what you did is better.

I finanlly decided to get a GROM unit and wanted to clafify. Will the following unit be the only Item I need if I decide to run the cable from behind the Radio instead of the CD Changer ...

Thanks for the info I have purchased a 2005 model from another individual. And thanks to everyone who PM'd me as well. If anything falls through I will follow back up.

Thanks I want to try for a week or two and source one for the same model first. Either way I will follow up with you. I thought there was something technically different from the 1991-2003 and 2004-2005 CD changes but maybe not.