35 or 25?
- Thread starter Biscuit
- Start date
Go with 25. It will be just perfect.
+1
I have 19x10.5" and an ET31 sits PERFECT, so the smaller 9.5" with a ET25 would/should sit exactly the same, heres how mine looks from behind and its VERY low.
I have 19x10.5" and an ET31 sits PERFECT, so the smaller 9.5" with a ET25 would/should sit exactly the same, heres how mine looks from behind and its VERY low.
Awesome! That really is perfect!
What tire width and suspension setup are you running?
What tire width and suspension setup are you running?
i have 18x8 et36 with a 215/35-18 and 19x10.5 et31 with a 275/30-19. IMO the 275 is WAY too skinny for the 10.5" the 295 would fit it better, but im going to go down to a 10" rim with the 275, should fit nicely. The wheel i want in back is only a 35offset, so ill run a small 5mm spacer if need be to keep the flush look.
Im running Tein coilovers and its LOW, like you have to drive car up onto a step of 2 2x12" boards (raise car 4") and even then sliding the snap on jack under it is VERY close/almost hits side skirts. But i drive like an old lady in a car. :wink:
Im running Tein coilovers and its LOW, like you have to drive car up onto a step of 2 2x12" boards (raise car 4") and even then sliding the snap on jack under it is VERY close/almost hits side skirts. But i drive like an old lady in a car. :wink:
Here is mine with a 19x9.5" +23 effective offset (I say "effective" because there is 6mm of spacer installed):
+25 will put the rim 2mm inward from this. So it'll basically look the same as here. . .
BTW, DEFINITELY make sure the rear caliper will clear the back part of the spokes. If you end up getting a +25 and need to run a spacer, you're kind of screwed. I ordered mine slightly less aggressive and had to run 6mm of spacer to clear the brake caliper (picture shown above has the spacer installed).
+25 will put the rim 2mm inward from this. So it'll basically look the same as here. . .
BTW, DEFINITELY make sure the rear caliper will clear the back part of the spokes. If you end up getting a +25 and need to run a spacer, you're kind of screwed. I ordered mine slightly less aggressive and had to run 6mm of spacer to clear the brake caliper (picture shown above has the spacer installed).
Last edited:
+1
I have 19x10.5" and an ET31 sits PERFECT, so the smaller 9.5" with a ET25 would/should sit exactly the same, heres how mine looks from behind and its VERY low.
your wheels do fit beautifully. That's exactly how they should look.:smile:
Similar threads
