• Protip: Profile posts are public! Use Conversations to message other members privately. Everyone can see the content of a profile post.

Car doesnt start

Joined
25 October 2006
Messages
346
Hello,

I use the search function and I found the Main Relay problem, but my Main relay is good.

What appen :
I drive my car in mountain, and the engine shut down.
When I turn the Ignition, I didn't hear the fuel pump.
Do I check the 15A fuse and all others fuses.
I connect the AEM EMS to my laptop and the ECU is not power on.
I check the main relay with a multimeter, (check relay,diode,resistor) and all is OK.
I remove the connector A, and I heard my solenoid, I connect the laptop to the AEM EMS and now I can see the sensor.
I plug the connector A, and can't hear the solenoid and the laptop can't connect to the AEM EMS.
I remove the connector A, and I heard my solenoid, I connect the laptop to the AEM EMS and I can see the sensor.

Strange :confused:

I disconnect the Main Relay, pump relay, I check all relay with the multimeter, and all relay are fine.

I reconnect the connector A, and now I can hear the solenoid and the laptop can connect to the AEM EMS, and the engine start.

I don't know what happen, is the NSX have a protection for fuel cut ?
 
Sounds like DMU needs reseating or is loose possibly on its way out. Do you have an aftermarket alarm?
 
Hmm remove the engine ground and clean the area it sits on.

Good luck
 
Back
Top