• Protip: Profile posts are public! Use Conversations to message other members privately. Everyone can see the content of a profile post.

Exterior ClearCorners LED Tail lights

Status
Not open for further replies.
Joined
21 February 2011
Messages
1,574
Location
So Cal
F/S: ClearCorners LED Tail Lights (will fit 91-05)

The project started with a set of 91-01 OEM JDM tail lights. Here is what was done:

Red parking lights
Amber signal lights
White reverse lights
Shaved lensing inside and out
Smoked diffuser
Smoked tail lens
Matte black housing finish
Illuminated center panel
Reverse lens adhesive refresh

Links for reference:
http://clearcorners.com/products/acura/nsx1/r_full1b/
http://clearcorners.com/products/acura/nsx1/r_center/

These tail lights are IMO, the best out in the aftermarket LED tail light realm. The custom cut and formed diffuser that goes over top the LEDs create an evenness to light output and doesnt look like the popular children's game that is Lite-Brite. These are a direct plug and play into the NSX's existing OEM harness. They do not have any messy additional wiring or separate control module. All of the components are sealed inside the tail lamps.

Here are some photos on hand for now but will update the post later with pictures of the lamp assemblies themselves off the car.

9412509258_98271b536c_h.jpg


Brake pedal compressed

9412524016_f356d104cf_h.jpg


Parking lights and emergency flashers on

9409748233_335694ba3e_h.jpg


Parking lights and reverse on

9412535864_2d4379a5c8_h.jpg


Parking lights, emergency flashers and reverse on

wqM4CTpl.jpg


Tail lights off

NSNrmh4l.png


Lights on, rolling

My personal preference was not to run the center lens illuminated but can get pictures of that also, just needs to be plugged in.

Asking $2,500. This is just under the cost of the conversion alone, not including the 3 piece OEM JDM lamp assemblies themselves.

PM here or e-mail robertna2 at yahoo dot com

Can deliver for free in So Cal area or buyer pays shipping.
 
Last edited:
What did you switch your tailights to? Or did you sell your car?
 
What did you switch your tailights to? Or did you sell your car?

Back to stock OEM JDM! Had been wanting to do this for A LONG time now but needed to first find tail light harnesses. My OEM one was sacrificed to complete this LED conversion. It really is a super clean install.
 
Status
Not open for further replies.
Back
Top