Does our factory NA2 (2002-2005) rims have these slots?

[EuroBoutique]

I've been looking at these 15mm spacers with integral studs but apparently the stock studs will protrude past the spacer a bit and I need to check if our stock NA2 rims have these notches??

see pics

 

[comtec]

This is the 02+ wheel. Depth 3mm x 25mm in diameter (approximately).

 

[Hrant]

No they don't.

Are you sure these are OEM? Do they have FORGED and JDM stamped on the front lip? What about RV718 or RV719 near the holes of the lug nuts? If they don't then it is not OEM.

 

[EuroBoutique]

Thanks for the post Comtec - guess I will just remove one wheel to double check because I plan on using some 15mm spacers up front and the oem studes will protrude past the spacer - how do you guys get around this when you want to use spacers up front?

I know my wheels are OEM as I saw the FORGED stamp last time when I was on my knees cleaning them


rick

 

[socalx]

how we get around this is if you are spacing 15 mm in front you use a spacer and longer studs. this is what i have on the front of my 05. in the rear i used a 25mm bolt on spacer.

 

[EuroBoutique]

how we get around this is if you are spacing 15 mm in front you use a spacer and longer studs. this is what i have on the front of my 05. in the rear i used a 25mm bolt on spacer.

thanks for the reply - I was trying to avoid swapping out the stud length since it's not so easy to do and need to bring the car to a shop for them to remove / swap correct?

Or is ok to bolt other wheels onto longer studs and I just have to use open face lugs? I have VOLK wheels and some other wheels I will use on the car down the road - using the OEM's is just a temporary solution.


rk