- Joined
- 16 August 2022
- Messages
- 55
I'm in the middle of a bunch of mods/maintenance, including replacing the alternator and compressor belts. So I figure I'd amortize my work and install the Cedar Ridge pulley shield from SOS. In theory, I can just remove the bolt at the end, pull the pulley, install the shield, and reassemble, correct (no issues with timing to worry about)? There's some kind of keyway for the pulley? I know the torques are high and it's gonna be a bitch, but is this as "simple" as I'm imagining?
BTW, I'm just about done with a Pride header install. That has been, without a doubt, the biggest PITA mechanical job I've ever tackled. It's not complicated, per se, but it's not fun trying to work around all the various conflicts and the limited space to reach fasteners.
BTW, I'm just about done with a Pride header install. That has been, without a doubt, the biggest PITA mechanical job I've ever tackled. It's not complicated, per se, but it's not fun trying to work around all the various conflicts and the limited space to reach fasteners.