A couple of years ago, a tech out of north carolina had one on a lift. I asked the same questions about where to lift in the center. he said the support structure goes pass the actual jack points. he could not remember how far and didnt want anybody missing that area.
I asked the same question. I was told that the center area does not have enough strength to lift the car. However, I saw a guy on you-tube do it while he was rebuilding a damaged one.I don't want to risk it
Because the sways go between lower chassis and engine, to do the sways, you'll have to lower and separate them and install the new part. The nsx tech said it is not a diy task. It would be pricey for minimal handling increases.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.