Recent content by GrigioTR

A complete set of 1993+ rims in great condition. $600 plus shipping. SALE PENDING NSX book. This is the black and silver one telling the NSX story. I believe this was done in 1991. Slight water damage on p. 2/3 center spread photo at the top. Otherwise fine. $50 plus postage. SALE PENDING...

Thanks for the info, I will start tearing into the CCU! Regards

Today my air conditioning motor stopped working then came back on. This continued during the entire drive. In addition the entire climate control panel went dark and nothing worked. Any ideas where to start looking? My first thought is a bad or loose connection, but would one connection...

A stock set of 15"/16" NSX rims. They are in good shape, but not mint. Used for the track by the previous owner and have old track tires on them. Can't tell you much more because they have never been on the car since I have owned it. I would consider trading for low mileage NSX Eibach...

I just listed a set on Seattle's Craigslist. Thought a local Prime member could be interested.

StevieRay, I cannot get a message to go through to you all are coming back as undeliverable. If this makes it drop me a note via [email protected] I still have your '91 and maybe we can meet up for coffee. Love to see the new one you have! Loren [email protected]

I am looking for OEM front and rear calipers for my '91. I intend to do some smoothing and painting and do not want to put my car on stands while I do the work. Thanks, Loren

Got it Thanks LarryB

I am getting ready to order some clothing from the NSXCA store and wonder how the sizing runs? Can anyone who has purchased shirts or jackets drop me a note. I am especially interested in length of sleeves to fit my 34/35 arm length. Or if you have ordered and have a contact e-mail address...

I have been considering changing out my oem 16/17's and from what I have been able to find out the 16/17's from Technomagnesio were the same width as stock. Does anyone know about offset versus stock? Now the big question, where can I find a set in either natural magnesium or black? All...

You have a PM Loren

Thanks to all, it was the mirror trick!!!!!!!!!!!!!!! All finished, now it'd beer time. Loren

So what should have taken 10 minutes has resulted it this post. The owner's manual says to use a phillips screwdriver and shows the location of the hole in the bumper. Piece of cake. Now after trying to engage the screw holding the assembly with both #1 and #2 screwdrivers in 4, 6 and 8 inch...

Thanks for the lead. Loren

Thanks for the tip. Unfortunately mine will need new pieces and a shop skilled at french seaming. Loren