Recent content by SpeedScience

Thanks man!

Couple videos of this finally moving and making noise! Getting ever closer to completion.

Been a little slack with updates but have a fairly massive one to share IT's ALIVE!!!!! <iframe src="https://www.facebook.com/plugins/video.php?href=https%3A%2F%2Fwww.facebook.com%2FSpeedScienceNZ%2Fvideos%2F1284404031606919%2F&show_text=0&width=560" width="560" height="315"...

Popped around this morning to drop some outer cv's off which will be machined down and then used to bolt the hubs/bearings together - no drive shafts means things are kinda sloppy up there! Figured I'd snap a couple pics while I was there. Wheels Work Emotion D9R 17x8.5 all round - 245 on the...

Back from the dead, kinda! Progress continues - wiring is 99% completed and once i have my rocker covers back and fluids topped up, various systems bled and the crank angle sensor polarity figured out - we can start her up! Rear diffuser is all but finished and exhausts reworked to come down...

THanks guys Yeah running lexan rear quarter windows so will have vents in those for throttle bodies and oil cooler. Some updated pics below!

So here is just a ton of pics - ttoo busy to write up blurb for each one!!

The C30 running gear is only around 100lb heavier than B series.....What we have stripped out in weight as part of the build we have probably put most back in in terms of rear subframe, heavier hubs, extra weight of plumbing and fluid on board and so on. I would probably guess it won't be too...

Thanks mate, Yeah motor in and out through the bottom - typically it'll be a case of just dropping the whole subframe down - subframe in it now so it can roll around. I hope it feels amazing! ;)

Grant and the boys at GT have been busy He just sent through pics on what they have been up to over the last week or so.Car is all but finished in terms of paint. The rear guards have been chopped and welded to suit flares but they can't be fitted until bumpers are on and ride height is set...

Ok more pics as promised!!!! Here is what they feature: - Throttle bodies from a few different angles. With all of that wiring taken off you can actually see that it looks like a motor! - Reinforcing of the inner skin where the oil filter sandwhich plate will mount and the access/drain plate...

Update! Science of Speed throttle bodies in place. 99% of the fab is done and car going to painters in a couple of weeks to get inside sprayed. More pics to come soon!

Some more work! Most of what is required from this point on is the fiddling stuff - nothing big and structural, but it takes time! So this is where things are up to Shifter is mounted and feels good Handbrake mounted, cables routed and brackets made. Coolant pipes under car run, bent and...

UPDATE!!! So, the day after I got back i went up to check out progress and there has been a lot!!! Exhaust is now completed Exhaust cover for "engine bay" is completed Fuel tank mounting more or less completed Water pipes/hoses to front of car mostly completed Some pics! ​

Some more updates!!!! Rear sway bar mounted. It mounts off the chassis in the NSX, not the subframe so had to make some custom brackets etc. Also had to chop the end of the headers off as it fouled on the sway bar. Fuel cell is more or less mounted, low and as far back as possible without...