Alpine CD changer, velcro installation?

[Ugly]

Anyone out there used velcro to insall Alpine CD changer to trunk floor panel/carpet? I am in the process of installing one and I do not want to drill thru the trunk for the brackets. Any suggestions?

Thanks in advance.

 

[PUREVIL]

I installed my old Alpine Changer into my X a few years ago but I drilled. I don't know if velcro would be able to hold it down. With all the bumps and cornering forces. But hey its worth a shot I guess huh?

 

[Gaymond Lee]

I use velcro to hold my 6 disc in place. I don't drive it too often but I didn't have any problems during the So Cal Canyonball run a few months back.

 

[L5]

I installed a Alpine S620 CD changer using Velcro (it took less than 5 min). No problem. A local car audio installer told me he would do the same.

 

[Jonathan.M]

I have used the same installation with velcro on the carpet on the right hand side of the boot. Works fine, I have no skipping and if I need to remove it it takes 20 seconds!

Good luck

Jonathan

 

[Nsxotic]

Same here, installed factory unit with velcro on left side......never a skip///

------------------
Pls. visit my site w/ lots of info and pics. Brand new classifieds and Message board. It may take a bit to download but it's worth it, I hope @
http://www.geocities.com/nsxcessive/index.html

 

[Jimbo]

I used Velcro to keep the unit in place in the trunk. Works fine.

I rarely put a lot of stuff in the trunk so it was not a big deal.

I guess if I traveled a lot with the car (like going to NSXPO...) I would rather have it mounted up and out the way on a bracket.

-Jim

------------------
1991 NSX Blk/Blk
1974 Vette 454 4 spd
Wht/Blk