ECU change - instructions

[hondasash]

Good morning gents,

planning to change my ECU so I have to access to and remove the old one first.
As I did not touch this part before, could someone explain me as detailed as possible how to access this part?
What has to be removed, what is just fixed with clips and what is screwed? Do not want to break anything loose

and yes, I have the manual but the manual - based on my opinion - does not explain it detailed enough

Thanks

 

[mwagner10702]

There are instructions in the Wiki

http://www.nsxprime.com/ecu-removal/

A Google search came up with this thread

http://www.nsxprime.com/forum/showthread.php/42172-ECU-Removal

The rear upper trim panel is made out of a fiber board material. Be careful not to pull the panel away from the clip and damage the hole that the clip mounts into. If this happens the panel will not be able to securely hold the clip when you get ready to reinstall it. When removing the upper trim panel you may break the panel clip(s). I would have a couple on hand in case this happens. The clip p/n is 91560-SL4-003.

The right and left rear panel trim (below the upper panel) are secured with different clips. The p/n for these clips is 90668-SJ4-003.

 

[hondasash]

thx man

There are instructions in the Wiki

http://www.nsxprime.com/ecu-removal/

A Google search came up with this thread

http://www.nsxprime.com/forum/showthread.php/42172-ECU-Removal

The rear upper trim panel is made out of a fiber board material. Be careful not to pull the panel away from the clip and damage the hole that the clip mounts into. If this happens the panel will not be able to securely hold the clip when you get ready to reinstall it. When removing the upper trim panel you may break the panel clip(s). I would have a couple on hand in case this happens. The clip p/n is 91560-SL4-003.

The right and left rear panel trim (below the upper panel) are secured with different clips. The p/n for these clips is 90668-SJ4-003.