Exhaust Install/Removing Cat Converter Bolts

Joined
1 October 2001
Messages
114
Location
Tuscaloosa, AL
I'm installing a Dali Wishuponastar exhaust on my 1991 NSX. I had to drill out the holes on the exhaust to get them to line up with the bolts that come from the catalytic converter. One of the bolts snapped off as I was tightening the nut and left the stud/bolt.

As the exhausted came with its own set of cat converter to exhaust bolts and nuts this should not be a big deal.

My question is: how do I remove the broken stud/nut from the cat converter?

Can I just drive it out with a hammer or do in need to cut the head off the bolt and drill.

Appreciate any help.

Drew Altemara
 
If the Dali exhaust includes any stainless nuts/bolts, be sure to put some anti-seize on the bolts. Ask me how I know to do this.

And yes, the studs in the cat are just pressed in. A wack with a hammer will get them out.
 
Back
Top