We have been making support plates and hardening front and rear motor mounts for rears. I finally came up with a new design, easier to make and a better part as well. Gives a larger volume for the Urethane so they will be more stable over time, saves 2 parts in each set so they cost less and are easier to install.
The plates center the parts of the original motor mount so you can use torn/ripped mounts and re-use them!
Parts cost:
$25 for a set(enough for one mount)
$45 for 2 sets(enough for 2 mounts)
We do not make plates for the upper motor mounts because I think those should remain open to absorb engine vibration, plus the 2 lower mounts are the ones which take the engine torque!
PM me if you want to get a set, we will ship(USPS) till June and an into offer.
We can also harden your mounts for $80 each, cast either 80 or 94 durometer Urethane in your mounts. I will offer free return shipping for this service if you are getting both mounts done and we usually can turn these around next day!
The plates center the parts of the original motor mount so you can use torn/ripped mounts and re-use them!
Parts cost:
$25 for a set(enough for one mount)
$45 for 2 sets(enough for 2 mounts)
We do not make plates for the upper motor mounts because I think those should remain open to absorb engine vibration, plus the 2 lower mounts are the ones which take the engine torque!
PM me if you want to get a set, we will ship(USPS) till June and an into offer.
We can also harden your mounts for $80 each, cast either 80 or 94 durometer Urethane in your mounts. I will offer free return shipping for this service if you are getting both mounts done and we usually can turn these around next day!
