Osiris_x11
Gold Member, Moderator: Marketplace
need to measure my F500BT & stuff...
Quite a creative & ingenuitive [sic] solution, I'm interested!
Quite a creative & ingenuitive [sic] solution, I'm interested!
***AVOID MARKETPLACE SCAMS!!***
Scammers are using compromised Prime member accounts to pose as a trusted seller in the marketplace. Before you enter into a deal with any seller, follow these tips to keep yourself safe. If you encounter one of these scammers, please report them immediately and we will lock their account.
Caveat Emptor!
Since there has been so much intrest in this bracket I am starting a list based on this thread and the one in NSX Electronics section. If others are interested please add your name to the list.
If you change your mind, please remove youreself from the list to make room for others.
I was only planning on making a limited run of 15 units. However please put your name down past the 15 in case some back out or if I make more the 15.
1. Josh
2. Bill_C
3. Veleno
4. afjnsx <--- is this me arfnsx?
5. semmons_NSX
6. Hrant
7. STMPO
8. OSIRIS
9. Pikko
10. Chippy
11. Hugh
12. Hugh
13. Got_Lip
14.
15.
Was #4 a mistype or do I need to jump on this list?
thanks
Sorry ... it was a mistype. Fixed now and you are on the list at #4. Here is the current list.
1. Josh
2. Bill_C
3. Veleno
4. arfnsx
5. semmons_NSX
6. Hrant
7. STMPO
8. OSIRIS
9. Pikko
10. Chippy
11. Hugh
12. Hugh
13. Got_Lip
14. R1uptempo
15. demigod
16. Sir Stunna Lot
17.
If the intrest continues I am going to see if I can cut more.
Pricing? Looks like they will be around $40 ea + paypal fees & shipping (USPS Flat Rate, unless you want it faster).
When I start to get them in my hads I will contact you via PM starting at #1 and go down the list.
Paypal information will be provided when I have the brackets ready to ship.
Thank you and please keep me on this list. I am happy with that price. seems fair.
Thank you for putting in the work on this product.
Appreciate the due diligence. Can you also provide the depth measurement from the bottom front of the Nav to the bracket screws so we can assess how deep of a screen would fit?
Ok ...
Installed in less then 10 minutes. All holes line up on both the lower vent and back Pod screw points, bracket does not touch the dash and the Nav Pod sits flush.
All is good as far a design standpoint so I'll give them the go ahead tomorrow.
Hopefully I can start shipping these by the end of next week.