Need a good shop in my area open on Saturday

[JIMSBLACK92]

I just purchased a new O2 Sensor but have now found that a special tool is needed to remove the dang thing. I'd like to install it myself but probably can't get under the vehicle anyway.
Also need both the rear and front alignment done
Thanks
Jim
Aptos/Santa Cruz
CA.

 

[Larry Bastanza]

Jim,

You actually do not need a special tool. A 22mm open end wrench will do. Remember: NO WD40/PBblaster, etc. You must take it out and install the new one dry.

Can't help on the alignment though

.

HTH,
LarryB

 

[Andrie Hartanto]

I know it is quite a drive, but Hilltop Auto Service open on Saturdays.

 

[Vytas]

You can also try Los Gatos Acura. I've been taking my car there (even though I have an Acura dealer a few miles from me here in Monterey) for five years and have their NSX tech, Gary, work on my NSX. The job was always done right the first time and I never took the car back to complain about any work done on my car. I've never taken my car to Don Lam (too far away) but everyone I've spoken to recommends him too and I believe his labor rate is much lower than the dealer.

Vytas

 

[JIMSBLACK92]

Thanks for the info, It's very much appreciated, I'm Happy to know that I only need a 22mm open end to get the sensor out and the new one back in

TGIF
Jim