Polished my engine support

[USAFguy22]

Since there aren't any aftermarket engine supports available that I know of, I decided to polish mine. It's a nice little dress up project if you have a few hours to spare. I just used progressively finer sand paper down to about 1500 grit. Results look pretty good!

 

[PSHUMARD1]

Nice job. i love doing little things that add nice touches like this.

 

[racer9x]

Nice, looks awesome, what grit did you start off with, wet sand or just dry?

 

[USAFguy22]

Started with a wire wheel to knock the big stuff off, then went with 120grit and worked my way down to 1500 grit wet sand. Power tools make this process much easier

 

[nikey22]

the two bolts that hold it in place, did you have to replace them? Did they have any red pain on the tip of the thread (sealant). Thanks.

 

[USAFguy22]

No they didn't appear to have any loctite or sealant on them, just two normal bolts that bolt into the block.