-
Protip: Profile posts are public! Use Conversations to message other members privately. Everyone can see the content of a profile post.
Group Buy Vivid Racing Advan RSII Wheel Group Buy
- Thread starter Vivid Racing
- Start date
-
- Tags
- advan group buy rsii vivid racing
looks great!
Jaffaz
I purchased a set of center caps but didn't like the looks of them with my wheels so I never put them on the car. Which style wheels did you get? My caps are black with advan written in silver or white. I need to check. I was planning on creating an ad to sell them.
I purchased a set of center caps but didn't like the looks of them with my wheels so I never put them on the car. Which style wheels did you get? My caps are black with advan written in silver or white. I need to check. I was planning on creating an ad to sell them.
Its going to tuck in once lowered. That's a proven size and offset. The black one above is the same size.
Freeon, don't worry it'll tuck in. Here's the pix to prove it:
Raised
<img src="http://www.nsxprime.com/photopost/data/500/Raised.jpg" />
Dropped
<img src="http://www.nsxprime.com/photopost/data/500/NoSpacer.jpg" />
Last edited:
Have any wheels sitting around Ahmed?or another group buy in the works ?
Thinking of selling my RSII 17 18 with AD08 tires. Setup has 800 miles on it. Just PM me if you want any info
- Joined
- 9 July 2006
- Messages
- 611
I'm about to find out for myself. My new suspension just showed up:biggrin: Will post picture when I'm done.
glad everything work out for you Freeon, ride heights vary from car to car, as long as it doesn't rub and it works for you, I tried to maintain that "rake" stance for the nsx with a ratio of front lower than rear by 1.5inch.
Where are you measuring the 1.5" at? From what I understand it is about 1/2" measured at jack points, 1.5" measured from points in the manual. Is this correct?
Last edited:
Hey Dave, I measure from the front center of lower control arm bolt to ground and for the rear the center of toe control arm bolt to ground. I was told that by measuring the jack point is not very realiable measurement.
Yes, that is what you should technically use, and that should be a 1.5" difference (less in the front). My issue is my installer is telling me that both there and at the jack points he is getting the same measurement which now I have serious doubts on. These measurement points are not on the same plane, the jack points are. So how can they be the same? I will have to go in there next time, take his beer away and break out my own tape measure. I think whether you go lower or not, that 1.5" difference at those points should be maintained unless you want to change the factory rake. First he told me the rake is off because I have 17's front and 18's rear. That should have tipped me off he is not on top of it.
^
Damn! Love it! Is that a wrap or a new paint job? Stoptechs look great in yellow.
You need your own build thread. This car looks really good.
Damn! Love it! Is that a wrap or a new paint job? Stoptechs look great in yellow.
You need your own build thread. This car looks really good.
