I've seen someone else with this damaged as well. Is it available as a separate part? As I recall, I could not find it in oemacuraparts or amayama parts diagrams for them.
You have to buy the whole wire harnesses to get this boot. I have seen someone used rubber epoxy “sugru” to patch it up, cut and sand it to shape and spray plasti dip black.
Unfortunately, the boot comes with the entire harness. You may want to reach out to some of the NSX-focused wrecking yards like AH Parts. Or, I bet that the boot is common among Hondas of the same generation. How much you want to bet you could find that boot on a Legend or Integra at your local pick and pull?
You can do a passable job with electrical tape if you plan it out. Go over the top first with 2 layers, perpendicular to the side opening, leaving the tape ends along the bottom. Then go along the bottom to cover all of those ends, leaving the ends on the tube for the side opening. Then wrap the tube for the side opening and cover those ends. Use a good tape like Scotch Super 33+ or even 88.
But definitely better if an Integra or Legend part from a wrecker fit. I do remember looking at Amazon & the like for something that would substitute without success.
The following boots work well, but are not concours
Jaguar X-type
2002-2013 Mitsubishi Colt (
(I had an hour to kill so scouted and acquired at junkyard. So available for trade or photos...BTW: I'm looking for the 3-pin connector that is on the radiator resistor or MVAC fan resistor)
Did anyone follow up with OCO Connectors? It would be interesting Usually I find such sites to post scraped down data and are awaiting for a payday of an inquiry. However, they might actually have a box of rubber boots laying around.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.