Recent content by mikerosi

This car has been sold

Hi guys. I`m trying to post an NSX for sale and cannot find a moderator to correct the problem. I don`t see any on that page. I am regstered and followed the stated rules but still no post. Thanks Mike

95 NSX with 98 K. Price: $31,500. This CA and AZ car has been dealer maintained and I have all service records. all maintanence, timing belt, fluid changes have been at scheduled mileage and time intervals. The one and only clutch replacement happened at 92K! Motor runs great and the body...

Have Antera 3 spoke 17`s and 16`s. Rear tires worn. Have 2 sets of 225-40 -16s -60% left. Also one set of 205-45- 16`s- 60% left, all Yoko A-520. All fpr $200. I`m in Santa Rosa area, 100 m North of SF. Call me at 7079954030, Mike

Antera 3 spoke wheels for 91 to 96 NSX. 2 sets of Yoko A 520 225 40 16`s 70% left. i set of 205 45 16`s 75%left . Rear 255 40 17`s 15% left. All for $300. Call Mike at 7079954030 or e-mail. I`m in SF CA area.

Dali Cross drilled rotor HELP I just bought some Dali drilled rotors (Bradi) and my kids mixed up the rotors. I know the fronts from the rears but I cannot tell the rights from the lefts. There is no L or R that I can see and can not get in touch with Mark. Could someone please tell me on the...

I just recieved 4 rotors for my 95 X and noticed all are 11 inches in diameter. I know the stock rears are smaller than that. Will these work on the rear? thanks Mike

I have a stock, non lowered 95 X. Will 225 45 16 work on the front without rubbing? thanks Mike

I need a set of cross drilled or power slot rotors. Where do you guys suggest I go to buy them? thanks Mike

I need rotors for a 95 NSX or information on where I can buy them, Thanks in advance, Mike

Also, has anyone had the coolant hoses that run through the center of the car burst? I am wondering about the longevity of these hoses and when I should change them

I checked my 60K service records and did not see my ABS hose replaced. I called the dealer and he said they inspect the hose and if it looks good they do not replace it. This sounds lame to me. How can they inspect the inside of the hose? What do you guys think? Just have it replaced, period...

I had a lower coolant hose by the engine burst on me at speed. Luckily I shut it down before I overheated. I got the new hose and will install it, but I`m going to drive it to the dealer to have the cooling system bled. The dealer is 60 miles away. Will I make it without overheating??? Thanks Mike

Rplacing coolant hoses I had the top coolant hose develop a pin hole leak while driving. It spewed white smoke while at 60mph. Luckily I shut it down before it overheated and had the car towed. I`m not sure how much coolant I lost. How hard is it to replace all my hoses as I have 90K and...

I purchased a used NSX with 88K and the timing belt was replaced at 75K along with leaking cam plugs. I have reciepts but it does not say if the valves were adjusted at that time. I`m trying to organize my maintanence schedule. Don`t you have to adjust the valves when you replace the belt or not...