hi!
Well, that is giving me some headache. After searching around for about 3 hours I am more confused than before.
My tire-dealer got a new allignment machine which only tells the shit in degree/minutes (60 minutes = 1 degree)
On the old machine from the same shop I had adjusted like that:
front toe -4mm
rear toe: + 6,7mm
Now whats that in degs/mins?
this is how I had adjusted today, but I am not sure if this is correct:
front toe: -52 minutes (-26 minutes each side)
rear toe: + 1 degree and 33 minutes (+45 left and +48 right)
whats this in mm about?
PS: I used S2000 16inch datas, because NSX was not in the computer of the machine. I run 17inch (215/40) front and 18inch (255/35) rear. How much does that affect?
thanks
Well, that is giving me some headache. After searching around for about 3 hours I am more confused than before.
My tire-dealer got a new allignment machine which only tells the shit in degree/minutes (60 minutes = 1 degree)
On the old machine from the same shop I had adjusted like that:
front toe -4mm
rear toe: + 6,7mm
Now whats that in degs/mins?
this is how I had adjusted today, but I am not sure if this is correct:
front toe: -52 minutes (-26 minutes each side)
rear toe: + 1 degree and 33 minutes (+45 left and +48 right)
whats this in mm about?
PS: I used S2000 16inch datas, because NSX was not in the computer of the machine. I run 17inch (215/40) front and 18inch (255/35) rear. How much does that affect?
thanks
Last edited: