Recent content by KraftwerkTurbo

His and Hers 1991 Auto and Manu

Ordered. Will be here next week. Will report back when installed (and crack open the old).

Very hard to find the clutch switch on this 1991 automatic transmission car.

Yes, wiggle and 30 attempts. no go.

Then accessories would not work, or? Everything works, just not when trying to start (no clicks, no crank). Headlights, radio, etc all work. Ignition switch contacts are often mentioned. Not sure how easy it is to open it (remove kickpanel, remove switch; then crack open the switch itself to...

Stored dry, heated, clean with battery tender. Good battery/voltage. Ignition on everythings works. With foot on brake pedal, lights dim a bit. What can cause a 'no crank'? What to check first?

Thanks Kaz! I have the manual (pdf scans) but it is difficult to navigate since it has not been digitized, so no search function. Will the 'code' (hate that blinking stuff, never had good look using it on other cars) tell if the issue issue pump, solenoid or wheel speed sensor related? Would...

Will do that first thing. Last time I did, there lights were off and I did not see any blinking ABS/TCS lights. I assume the codes went away. Also (just to be sure): will check fuse #32 (IIRC, for ABS pump). Is there also a relay for the pump? If so, location?

I tried the small hand bleeder, but failed. As mentioned earlier, the method fails IF the bleeder valve has to be opened farther than the threads seal. In which case (good idea, will try next time), wrapping in teflon seal tape actually may make this method useable. Still requires a lot of...

In warm garage, did some work on the car (AC system now working again). In light of the ABS and TCS lights on, also flushed the brake system (main reservoir on master cylinder), and sucked out old fluid from the small (clutch) and ABS pump reservoir. All new fluid is ATE brake fluid. Took car...

Looking for the ABS pump activation harness, ABS solenoid exercise harness, and the special T bleeder tool for the ABS pump. Shipping to 48114. Let me know.

Wish they were mine instead of my friend's. Only taking care of them.

How (what did you use, tools, harness, etc?) did you do it? Both pump flush and solenoid flush?

Best way to go about getting the harness (to activate the solenoids), pump switch (no messing with wires/shorts) and the Bleeder T Socket?

Looks like I could use the set (pump switch, solenoid trigger). How to order? Or who has one for sale?