I just bled my ABS and it went well - I thought. I got alot of white-ish foam at first then it became clear and clean. I took the car for a test ride and the ABS motor would not stop. It ran for the 120 secs. and cut off and the ABS light came on. When I got back from the test drive the reservoir was empty. I rebled the system and more white foam. I ran the car again and same 120 secs and off. I then tried to flush the solenoids. 2 of them returned foam to the reservoir when activated but 2 of them didn't do anything even though I could hear them activating. Another test drive and this time the ABS motor stopped after several hard stops (again upon return the reservoir was empty - does this cause air in the system? - and I am filling it to max before driving). But now the motor runs for about 5 to 6 seconds after engaging the ABS and it did not do that before.
Any ideas - Please? And please no "just disconnect the POS thing" comments.
Thank You
Any ideas - Please? And please no "just disconnect the POS thing" comments.
Thank You