I recently installed a set of DC5-R Recaros and used the seat belt assembly from the OEM seats. The driver's side seat belt assembly has a gray connector that originally plugs into a blue connector coming from the OEM seat, which then eventually becomes a gray female connector that plugs into the gray connector coming from the floor. For those of you with aftermarket seats, what did you do to make the seat belt sensor work as intended without removing the wire harness and connectors from the OEM seat? Without this connected, the seat belt light on the dash lights up continuously. Is there another wire harness I can buy that will connect the seat belt connector straight to the connector coming from the floor? If not, does anyone know what each pin represents on the connector coming from the floor so that I can create my own wire harness from the seat belt connector directly to the connector coming from the floor? Any help or recommendations would be greatly appreciated. Thanks in advance!
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Last edited: