My speedo has been bouncing all over the place. I am worried the needle or speedo is going to get damaged before I can replace the sensor. The ccomputer code shows the sensor is the problem (at least this is what I was told). Can I unplug the speed sensor so my speedomoeter quites bouncing around? Will it hurt the engine if I leave the sensor unplugged for a week or two until I can get a new one? I found one cheap on Ebay.
Where is the speed sensor plug located so I can unplug it? I need help from some of you pros out there.
Where is the speed sensor plug located so I can unplug it? I need help from some of you pros out there.