Recent content by RuInnovations

Unfortunately no. I only have pictures in a different vehicle (a '94 Accord, the only vehicle that I had access to with a tape deck)

If you see the new pictures either on the site or the thread here, you will see that the new design that has been out for a while is push in/pull out as necessary. How thin are you thinking you'd like it made?

Thanks! Boiler Up!! I've got your card on my desk! He only had good things to say about you guys

Bump! All products still available and ready to ship! Discount code nsxprime still honored through my website.

Bump! All products still available and ready to ship! Discount code nsxprime still honored through my website.

Bump! All products still available and ready to ship! Discount code nsxprime still honored through my website.

The different need for 'thin' vs 'thick' really depends on what phone/case you use. Thin should fit most phones and slimmer cases. Once you start to get into the Otterbox/thicker cases is where the 'thick' version would be necessary. I am certainly still offering the nsxprime discount code! I...

Bump!

Bump!

Bump!

Bump!

bump!

bump!

If you mean 200-300 degrees in Fahrenheit, then I think there should be no issues. ABS glass transition temp (when it will get soft) is around 105C (221F). 'Melting' point is about 200C (392F). So there's a chance the piece may soften up, depending on the bay temp, but I don't see it melting if...

PM sent! This is actually part of the new 3D printing services I have begun to offer through my site. Look forward to helping you out!