removing turn signals

[diddy]

im trying to remove my front turn signals to replace some bulbs but for the life of me i cant figure out how to remove them. could i get some help?

 

[E-Nough Logic]

There is a hole in the bumper underneath the light on the inner side that you can get a screwdriver in. This is the only screw holding it in, there is a tab on the other side. Even with this screw backed out it can be tight. Also, the screw doesn't come completely out, there is a locking type washer that holds it, and helps for easier installation.

 

[Caroline-NSX]

If you look under where the turn signal lamps is and look up there is a small holes the will require a long four head screw driver to unscrew the screw. After the screw is fully unscrew push the lamps in a couple times and lamps should come right out and you'll know what to do from there :smile:

 

[TyraNSX]

There is nothing new under the sun. It's in the owner's manual too.


http://www.nsxprime.com/forum/showpost.php?p=773121&postcount=2

Also in Wiki http://nsxprime.com/wiki/Bulbs

 

[joboy77]

If you look under where the turn signal lamps is and look up there is a small holes the will require a long four head screw driver to unscrew the screw. After the screw is fully unscrew push the lamps in a couple times and lamps should come right out and you'll know what to do from there :smile:

Yes, it takes a very long screwdriver.

 

[Caroline-NSX]

There is nothing new under the sun. It's in the owner's manual too.


http://www.nsxprime.com/forum/showpost.php?p=773121&postcount=2

Also in Wiki http://nsxprime.com/wiki/Bulbs

There is always something new under the sun :smile:

 

[diddy]

thanks guys for the help. knocked it out.