I want to do a valve adjustment on my Integra tomorrow, but can't find the valve gap specs. Anyone have any idea?
It's a '94 Integra RS (non-VTEC).
Thanks, SF
It's a '94 Integra RS (non-VTEC).
Thanks, SF
-
Protip: Profile posts are public! Use Conversations to message other members privately. Everyone can see the content of a profile post.
Integra valve clearance?
- Thread starter SF944
- Start date
Every NSX owner has a service manual for a 1994 Integra at home, right? Mine says, for the RS:
Intake: 0.08-0.12 mm (0.003-0.005 in)
Exhaust: 0.16-0.20 mm (0.006-0.008 in)
Measured when cold.
The procedure is on page 6-3. You should really have a service manual if you're going to be working on your car...
(Note - these are not the same as the specs for the GS-R, so if you have a GS-R, don't use them; the GS-R specs and procedure are on page 6-44.)
-------------------------
'91 NSX
'94 GS-R
'01 ITR
Mine says, for the RS:Intake: 0.08-0.12 mm (0.003-0.005 in)
Exhaust: 0.16-0.20 mm (0.006-0.008 in)
Measured when cold.
The procedure is on page 6-3. You should really have a service manual if you're going to be working on your car...
(Note - these are not the same as the specs for the GS-R, so if you have a GS-R, don't use them; the GS-R specs and procedure are on page 6-44.)
-------------------------
'91 NSX
'94 GS-R
'01 ITR
Thanks, you made my morning
This was kind of a last-minute project a mechanic friend of mine is helping with. He (hopefully) knows the procedure but the actual specs would be tough to find on a Sunday morning!
Thanks again.........--Scott
This was kind of a last-minute project a mechanic friend of mine is helping with. He (hopefully) knows the procedure but the actual specs would be tough to find on a Sunday morning!
Thanks again.........--Scott
Similar threads
