Recent content by ousi

Sold. Thanks!

1991 NSX Red/Black (Front-end damage) 5spd 117k miles (SOLD) YEAR & MODEL 1991 NSX FULL VIN #: JH4NA115XMT000075 CURRENT MILEAGE: 117044 miles (Not Actual Mileage. Original not working, replaced with a used one and was reset to 111111 miles when replaced January 2012.) COLOR (EXT/INT): Red /...

Photos look really cool. I still need my friend to figure out how to tune down the fuel pressure or else I'm going nowhere...

Sold to J-RnsxT. Please lock thread.

Tein Mono-flex that came with my car when I bought it. Recently upgraded to JRZ RS so don't need them anymore. Mileage unknown, but these look really new. I will clean them if it's not raining. These are pics taken without cleaning - straight off from the car. Comes with the 2 wrenches and...

That was me at West Coast Armory. I'm a member there learning how to shoot ;-) Those are colonial Hong Kong sticker. Just saw a black NSX on 156th. Didn't have time to say "Hi" coz I was in a hurry...

Nothing else about powertrain, the car came with Comptech header and Exhaust, plus SOS bored TB, intake scoop already. For maintenance - water hoses, Koyo radiator, new thermostat, intake manifold overhaul, new spark plugs, new coil packs, timing belt/water pump/new crank pulley, crank seals...

My car is finally back from a 2-month maintenance with lots and lots of stuff done on it (70% maintenance). Very noticable increase in torque/power in low rev range (1-3k), better gas mileage around town due to the increased torque probably. Haven't ask my friend to try it out and compare to...

That's probably me. I was heading to Vancouver with my friend. It's good my car is finally back from a 2-month maintenance :)

Thanks, I got the installation guide. Will you put it on your website so that anyone that has a doubt about installation can refer to it? :)

I'm installing it with my mechanic and we are both confused. The intake manifold was lifted from the engine (my car is in a lengthy maintenance), so we can take a really close look at it. The hard plastic spacer on the "hole" is took off, and the black rubber seal is put in there. But we have...

Seems like the GB is closed...was too busy earlier this month :( I want the rear tie bar...don't know how I can get it though...

I got a quick response from Brian. He said: 4 and 7 on the diagram.

I received mine. It actually took Brian 1 week to ship. Anyway, I am confused as to what has to be removed. Here's a diagram: http://www.hondapartsunlimited.com/find-parts/Acura/NSX/1991/2DR%20NSX/KA5MT/FUEL%20INJECTOR%20%281%29 So, which parts need to be gone? 17 or 3? 2 or 4?

I ordered a set earlier this week and waiting for it to be shipped! Looking forward to have this installed to replace my old 240cc OEM injectors. In my case I just need the ROM and the install kit, because my ECU has ZIF installed.