Recent content by playswfire

Car sold

Car Information Year: 1991 Type: NSX coupe Transmission: 5-Speed Exterior color: Black Interior color: Ivory Odometer: 173000 mil VIN: JH4NA1159MT002402 Price: 30000 OBO Car History Title History: Current title is clean. No known branded title...

I finally got it together - can I get in on one of these?

I would like to get one of these - just saw that I am in the market for one

Sold

Taitec JGTC parallel exit exhaust, for 91 - 96 $800 plus shipping from Atlanta area (30101) E-mail at [email protected] This picture is not of mine, photos available

I was able to replace the mast for about $60 after mine got broken by an errant garage door, about 10 minutes

Manufacturing Engineer for Philips Home healthcare Solutions (formerly Respironics, formerly Healthdyne) in Kennesaw Beekeeper on the side

Check the fluid level, I found I ran it dry; Follow the steps, top it off, then start it up, then top it off again. in my case 30 seconds of run time on the pump didn't nearly pump it up as much as normal operation.

I PMed Fireballs - waiting for address to send it to. I'm trying to get a less than 1 week turn around.

My test was with a stock, normally aspirated vehicle, probably makes a difference - computer has to make a lot of allowances for the reduced AKI in the highly modded vehicle running nearer the edge. I was also not running hard, just cruising 80-90 mph for 300 miles each way; probably makes a...

When I tested it, I found no difference between mileage with premium and regular, shell vs BP vs "Starvin Marvin" (took about a year) - 90% highway driving in a 240SX doing a randomized trial (unfortunately the data went with the 240). Conclusion: to reduce cost, use the cheapest stuff...

Thanks for the feedback; I was under the impression that R12 was not available any more, so I will check it out. I would prefer to go that route. Also, the last vehicle I tried to convert was an RV that probably had other issues - incompatible oil in it that had to be purged prior to...

Now that the snow in atlanta has finally melted, I ran the AC for a bit and ... nothing (well, air blew out of the vents proportional to the fan setting, but no coldness). The compressor clutch was engaged, the condenser fans were going, even had a little drip of condensation out the bottom -...

I used popsicle sticks (kids craft stuff) as shims and jacked the clips loose. Used "liquid nails" around the perimeter of it, clamped it using spring clips over popsicle sticks. Came out looking pretty good. Rebuilt the screw tabs on the bottom using surgical facial bone plates and 1.3 x 3mm...