Recent content by rickmnsx

About one - properly! Mine was $2000.

BUMP. Still have these for sale and would be happy to talk to anybody interested. Any reasonable offers will be entertained. Am available in Phoenix for the winter now.

I have just gone through a wheel and tire conversion at SoS to accommodate the install of new Brembo' s on my car and as a result have the following VERY LOW mileage UNMOLESTED UltraHP tires for sale (FOB Phoenix) for MY '97 - '02 OEM wheels (R17") - will ONLY be SOLD IN PAIRS ...

I have just gone through a wheel (Rays TE37's) and tire (Direzza ll *Spec) change to accommodate the install by SOS of new Brembo' s on my MY 2000 and as a result have the following low mileage unmolested Ultra HP tires for sale (FOB Phoenix):2 Bridgestone Potenza's RE010 245/40 ZR17 - tread...

How about registration?

Are you happy with your LeatherSeats leathers? Did you get them installed yet and if so what was the final installation cost?

Ready to buy 2002+ OEM wheels. Please PM me with pricing and shipping costs to Phoenix.

- - - Updated - - - TURBO2GO, I think you have the part on backwards. The nipple part is supposed to go through the hole in the liner (its top face should be flush with the face of the Liner) and this would then orient the clip so that the angled portion of the clip is actually applying...

Follow up to earlier post - not sure what # 19 is now, but at the hole 5 position from the bottom of the Liner is PN 74103-SL0-000 (which is #9 on the drawing) which is a little arm that rather than being screwed into is actually clipped into with a small push clip (#23 I believe). The push...

I used LA Prep Inc., 2701 Signal Parkway, Signal Hill, CA 90755 (562) 592-8886 to get my pristine 2000 NFR NSX-T from Columbus OH to Phoenix last Spring. I have to say I was initially concerned about the quality of the transporter that I had hired to deliver my car (unless you have done it...

NSX fender clips #19 is 5th up from the bottom of the liner - first 2 are screws with washers, the next 2 are push clips and then #19 is a little arm (attached to a screw through the plastic body of the clip) that swings over the inside of the fender lip - when you tighten the screw the little...

I guess if the ducts actually weighed less they could have used something nylon or equivalent that is less "structural"! Those look pretty beefy. Imagine all the new parts they had to create just because it was aluminum. As a new owner I never really thought too much about this before. Sort of...