Recent content by SDHeights

bump

Hello Anytime - a few months back I posted a listing for my 2001 NSX for sale. It was authorized and viewable for a while, then for some reason vanished. Is there anyway of getting the original posting re-posted? Thanks, Jeff

VIN #JH4NA21661T000066 Summer is here! Beautiful ’01-T Silverstone 6 speed manual in near showroom condition. 35.7K miles, solid 9.5 inside and out. This car turns heads left and right. Items refreshed while on my watch: New OEM floor mats Fuba short antenna (Beta D Flex P/N 17237) R...

I'm expecting a new toy soon and was looking for a car cover. I saw a picture of a nice, tight fitting red cover with the NSX lettering on the front nose - in silver I believe. Anyone have any idea where to find something like this? Thanks, Jeff

Sorry! Has to be silver. The '00 is a hard core race setup - not what I want. Think I may have dialed in on a '00 in Florida however...

I know this has been discussed, but I could not dial in on an answer from the information on previous posts or the FAQ. Please don’t respond with “that’s been asked, just search”. I’m now looking at a 2000. The ‘93 I had the very distinct engine vibration in the 1200 to 1500 rpm range, which...

Turbo2Go, you have a very good point, which is actually something that just dawned on me too. The pure depreciation of the M coupe is going to be significant, and something that is very difficult to get out of if I want. On the other hand, the NSX will hold its value substantially better at...

Hi guys - I'm back from a couple year hiatus- I owned a 93 awhile back. I’ve got $50K to blow on a car and am struggling with what to dial in on. Basically it seems to be a 2000 (ish) NSX, or a new BMW Z4 M Coupe… The draw back on the Z4 that stands out in my mind is the front engine...

This is a 1993 (VIN# JH4NA115XPT000100) 100th car built in the year. These are the features of the 93 versus the earlier models (from nsxprime): - Added cup holder to center console (console cover has two separate openings) - Added Passenger Side Air Bag - Changed Rear Alignment to...

Is it required to remove the complete front bumper to re-paint the skin? I believe that I saw a posting that addressed this, but cannot find it. Thx

Noticed a new sound today - sounds like perhaps a $1K one :biggrin: ... While going uphill on a constant, but not too steep of a hill, a gradual clunking noise started from the back end. Rate is constant with the wheel speed, not the engine speed. It gets louder and more pronounced after...

One thing noticed on mine was that the timing belt was quite loose when changed. The belt actually drives the pump, but from the back (non-toothed) side of the belt. It was loose enough that the pump could be easily spun by hand. I don't know if there is more tension applied during normal...

Found it - thanks.

Ok, it's getting cold here in Albuquerque - heater does not work. Im thinking the Air Mix Control Motor is not functioning. Apparently, this motor controls two flaps the cover the heater core via a cable. Anyone know where the actual motor is? Inside cabin? In hood area? Left, Right side...

Found the problem - not an engine missfire at all. Timing belt was very loose. Did the belt, water pump and idler pulley. Sounds and feels much much better! There is still a broad spectrum of low vibration throughout the high idle range, but this I will buy as normal. The previous vibration...