• Protip: Profile posts are public! Use Conversations to message other members privately. Everyone can see the content of a profile post.

sensor

  1. B

    Powertrain WTB: Crank Cylinder Sensor (aka Cam timing sensor)

    1991 NSX, I am looking for the cam timing sensor, I think the part number is 37840-PR7-A03. Thank you very much!
  2. JGibbs

    SRS Senors with Brackets - Left and Right

    SRS Senors for a 1991 NSX. These sensors came with the car when I bought it as spare parts. They appear to be new, and never installed. I have never installed/tested them myself and was planning on tossing them since my SRS is working well. Offering them up here in case anyone needs them! $50...
  3. Yawwn

    After 90k service, getting CEL code P0336

    Hello all, I recently had a 90k service on my silver NSX, including replacing the timing belt. After doing so, I got a Check Engine light. I used the paper clip method of pulling the code, and saw that it had 4 long blinks and 2 short blinks, which corresponds to the following: "Crankcase...
  4. Stevon

    Interior WTB 93+ seatbelts W/SRS plugs

    I have a set of 91 seatbelts installed in my 95-T. Ergo SRS light is on. Parts and/or adivice to fix SRS light would greatly be appreciated. Stephen
  5. Stevon

    95 NSX with 94 trans no NC spd Sensor! Code 33

    I have a 95 NSX-T 5 speed that I put a 94 5 speed trans in with an OS Giken differential. Now that my 7 -1/2 year car project is registered I see EPS light coming on and power steering goes dead. Reset with fuse but light comes back on. Replaced the rack ground strap with new overkill wire and...
  6. POWERED by HONDA

    Need help identifying part connected to horn

    What is this part that is connected to one of the horns? I found it dangling after removing the radiator duct to install the STMPO front chassis bar. Thanks in advance! --Conrad
  7. Stevon

    Exhaust ODBII secondary O2 test simulator

    Have for sale secondary O2 sensor simulators for testing and off road use only! Simulates heater and readings of secodary sensors to ECU so no error codes are shown while testing. The connectors just plug into ODBII compliant NSX harness, one male and one female connector for each bank of...
  8. 5inchfatlip

    Need working speed sensor for 93..

    I have the famous jumping speedometer needle. Works fine after the car has warmed up, but would like a working one for somewhere around $50. I believe it is located right under the air filter. thanks
Back
Top