Ok, so I was installing my failsafe gauge to monitor my already installed water/meth kit.
But, when I tried to run the flow sensor from the failsafe into the methanols kit's line...they didn't match each other!!!
Why in hell would AEM make the failsafe and the water/meth kit's lines in two different diameters ??
The holes on the flow sensor are alot smaller than the line's diameter coming from meth kit/pump!!!
That brought my install to a halt pretty quick...
-MSR
But, when I tried to run the flow sensor from the failsafe into the methanols kit's line...they didn't match each other!!!
Why in hell would AEM make the failsafe and the water/meth kit's lines in two different diameters ??
The holes on the flow sensor are alot smaller than the line's diameter coming from meth kit/pump!!!
That brought my install to a halt pretty quick...
-MSR